Genfloor / Acrylic Floor and Road Marking / 624 Genfloor Road
ACRYLIC FLOOR AND ROAD MARKING · MARKING PAINT
624
Genfloor Road
2K · Solvent-borne epoxy · Line marking
High-adhesion epoxy line-marking paint for lanes and markings on industrial floors.
A two-component, solvent-borne, epoxy-based line-marking paint with high adhesion and mechanical strength.
Technical Data
LIANT
Epoxy resin
COMPOSANTS
Two-component (2K)
POSITION DANS LE SYSTÈME
Marking paint
DENSITÉ
1.65 ± 0.1 kg/L
EXTRAIT SEC EN VOLUME
50% ± 3
DILUTION
016 Gen Epoxy Thinner
MÉTHODE D’APPLICATION
Brush, roller
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
SÉCHAGE
—
CONDITIONNEMENT
—
TEINTE
White, yellow and RAL colours on request
DOCUMENTS TECHNIQUES
Utilisation et application
DOMAINES D’UTILISATION
Used for marking lanes and special signs in factories, assembly workshops, warehouses, aircraft hangars, car parks, cycle paths and on all industrial floors.
PRÉPARATION DE SURFACE ET APPLICATION
The surface must be clean and dry; mark out the line edges with masking tape. Mix components A and B with a low-speed mechanical mixer until homogeneous (at least 2–3 minutes) and apply the mix within its pot life. Apply by brush or roller. Ambient and floor temperature must be between +10 °C and +30 °C and relative humidity below 80%; floor temperature must be kept at least 3 °C above the dew point.
DOMAINES D’APPLICATION
→ Factories and Production Plants
→ Warehouses and Logistics Centres
→ Roads, Cycle Paths and Walkways
Technical data are average values at 20 °C and 65% relative humidity. Coverage varies with surface roughness, application method and film thickness. Consult the Gen Boya technical team for project-specific system design.
POINTS FORTS
— High adhesion
— Lines resistant to forklift traffic
— Compatible with epoxy floors
— Sharp, durable marking
SYSTÈME RECOMMANDÉ
—