Genfloor / Hygienic Wall Coatings / 626 Genfloor Topcoat Wall
HYGIENIC WALL COATINGS · WALL TOPCOAT
626
Genfloor Topcoat Wall
2K · Solvent-borne epoxy · Wall
Solvent-borne epoxy topcoat for industrial vertical concrete walls.
A two-component topcoat based on solvent-borne epoxy resin. It forms a washable, chemical-resistant and hygienic wall coating on vertical concrete surfaces.
Technical Data
LIANT
Epoxy resin
COMPOSANTS
Two-component (2K)
POSITION DANS LE SYSTÈME
Wall topcoat
DENSITÉ
1.60 ± 0.1 kg/L
EXTRAIT SEC EN VOLUME
55% ± 3
DILUTION
016 Gen Epoxy Thinner
MÉTHODE D’APPLICATION
Roller, brush, airless spray
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
RENDEMENT
—
SÉCHAGE
—
CONDITIONNEMENT
—
TEINTE
Produced on request in colours from the RAL colour chart.
DOCUMENTS TECHNIQUES
Utilisation et application
DOMAINES D’UTILISATION
Used in factories, assembly workshops, warehouses, aircraft hangars, shops and car parks, food plants, hospitals, the chemical and pharmaceutical industries, power plants and on all industrial vertical concrete walls.
PRÉPARATION DE SURFACE ET APPLICATION
The wall surface must be sound, clean and dry; remove dust, oil and loose parts. Prime the surface with 643 Genfloor Primer Impregnation SB. Mix components A and B with a low-speed mechanical mixer until homogeneous (at least 2–3 minutes) and apply the mix within its pot life. Apply two coats by roller, brush or airless spray. Ambient and floor temperature must be between +10 °C and +30 °C and relative humidity below 80%; floor temperature must be kept at least 3 °C above the dew point.
Technical data are average values at 20 °C and 65% relative humidity. Coverage varies with surface roughness, application method and film thickness. Consult the Gen Boya technical team for project-specific system design.
POINTS FORTS
— Formulated for vertical surfaces
— Washable, hygienic surface
— Chemical resistance
— Economical roller application
SYSTÈME RECOMMANDÉ
PRIMAIRE
643 Genfloor Primer Impregnation SB