top of page

Genfloor / Polyurethane Systems / 834 Genfloor Polyurethane Floor Topcoat

Gen Boya 834 Genfloor Poliüretan Zemin Kaplama Topcoat ambalaj görseli

POLYURETHANE SYSTEMS · UV-PROTECTIVE TOPCOAT

834

Genfloor Polyurethane Floor Topcoat

2K · Polyurethane · UV resistance

Polyurethane protective topcoat for floors requiring UV resistance outdoors.

A ready-to-use, two-component, polyurethane-based protective topcoat with high UV resistance. It provides colour and gloss retention over epoxy floor systems.

Technical Data

LIANT

Polyurethane

COMPOSANTS

Two-component (2K)

POSITION DANS LE SYSTÈME

UV-protective topcoat

DENSITÉ

1.30 ± 0.1 kg/L

EXTRAIT SEC EN VOLUME

60% ± 5

RENDEMENT THÉORIQUE

4 m²/kg (single coat)

RAPPORT DE MÉLANGE

4 : 1 by weight (A : B)

DILUTION

018 Gen Polyurethane Thinner

MÉTHODE D’APPLICATION

Roller, brush

RENDEMENT

—

RENDEMENT

—

RENDEMENT

—

SÉCHAGE

—

CONDITIONNEMENT

15 kg kit (12 kg A + 3 kg B)

TEINTE

Produced on request in colours from the RAL colour chart.

DOCUMENTS TECHNIQUES

Utilisation et application

DOMAINES D’UTILISATION

Used as a protective coat on all kinds of metal surfaces and as a topcoat on epoxy floor coatings, particularly outdoors where UV resistance is required.

 

PRÉPARATION DE SURFACE ET APPLICATION

The epoxy floor to be coated must be clean, dry and lightly sanded. Mix components A and B with a low-speed mechanical mixer until homogeneous (at least 2–3 minutes) and apply the mix within its pot life. Apply in thin coats by roller or brush. Ambient and floor temperature must be between +10 °C and +30 °C and relative humidity below 80%; floor temperature must be kept at least 3 °C above the dew point.

 

DOMAINES D’APPLICATION

→ Car Parks and Ramps

→ Outdoor Areas, Terraces and Roofs

 

Technical data are average values at 20 °C and 65% relative humidity. Coverage varies with surface roughness, application method and film thickness. Consult the Gen Boya technical team for project-specific system design.

POINTS FORTS

— High UV resistance

— Resistance to yellowing and chalking

— Topcoat over epoxy systems

— Also suitable for metal surfaces

SYSTÈME RECOMMANDÉ

PRIMAIRE

Applied over epoxy floor systems (659, 660).

Le bon système pour votre sol, avec l’équipe technique Genfloor.

Nos experts vous accompagnent à chaque étape : analyse du support, mesure d’humidité, choix du système et calcul de consommation.

bottom of page