Gen Rapid Primer
Rapid alkyd resin based, air drying primer.
Surface Preparation and Application Method
The application surfaces should be cleaned of any substances that may reduce adhesion. Metal surfaces should be sandblasted (sand blasted) to a minimum of Sa2 ½ (ISO 8501-1, SSPC-SP10) and the blasted surface should be primed with Gen Rapid Primer within 6 hours. The product, which is diluted according to the application equipment, is applied by mixing thoroughly until it becomes homogeneous. After the primer has dried (after 4 - 6 hours), the final coat is applied. The surface temperature should be at least 3 degrees higher than the dew point temperature. Application should not be done near the dew point. It is necessary to wait 24 hours between the coats in the final coat application. Application Temperature: Min +10°C / Max +30°C.
Dilution / Mixing Ratio
It should be applied by diluting with max. 15-20% industrial thinner.
Intensity
1.65 ± 0.1
Solid Volume
58±3
Recommended Application Appliances
Air - airless spray
PACKAGING
1kg - 3kg - 15kg
