Gen Marine / Tank and Special Coatings / 608 Gencoat HB Phenol
TANK AND SPECIAL COATINGS · TANK LINING
608
Gencoat HB Phenol
2K · Phenolic epoxy · Cargo tanks
Phenolic epoxy, high-solids tank lining applied at high build in a single coat for chemical and cargo tanks.
A phenolic epoxy, high-solids, high-performance tank coating for chemical tanks. It shows high resistance to a wide range of chemicals such as petroleum products, alkalis, various acids and methanol, and can be applied at high build in a single coat.
Technical Data
LIANT
Phenolic epoxy
COMPOSANTS
Two-component (2K)
POSITION DANS LE SYSTÈME
Tank lining
DENSITÉ
1,40 ± 0,1 kg/L
EXTRAIT SEC EN VOLUME
%62 ± 3
RENDEMENT THÉORIQUE
4,1 m²/L (150 µm DFT)
DILUTION
Gen Epoxy Thinner
MÉTHODE D’APPLICATION
Airless spray, brush (stripe coat)
PRÉPARATION DE SURFACE
Sa 2½ (ISO 8501-1)
NOMBRE DE COUCHES
2–3 coats (total 300 µm DFT)
RENDEMENT
—
RENDEMENT
—
SÉCHAGE
—
CONDITIONNEMENT
—
TEINTE
—
DOCUMENTS TECHNIQUES
Utilisation et application
DOMAINES D’UTILISATION
Cargo oil tanks, fresh water tanks, holds, solvent tanks and chemical tanks.
PRÉPARATION DE SURFACE ET APPLICATION
Blast steel to ISO 8501-1 Sa 2½ (roughness 40–75 µm) and remove salts, grease and dust. St 3 power-tool cleaning may be used for local repairs. In tanks, remove all blasting dust and stripe-coat welds and edges separately. Steel surface temperature must be at least 3 °C above the dew point and relative humidity below 85%. Use the mixture within its pot life.
ZONES DU NAVIRE ADAPTÉES
Technical data are average values at 20 °C and 65% relative humidity. Coverage varies with surface roughness, application method and film thickness. Consult the Gen Boya technical team for project-specific paint specifications and system design.
POINTS FORTS
— Wide chemical resistance (petroleum products, alkalis, acids, methanol)
— High build in a single coat
— High solids
— For cargo and chemical tanks
SYSTÈME RECOMMANDÉ
—